INVESTIGATOR 563

Beautiful job Andrew. Well done

Good Job Andrew, keep the progress photos coming mate. Cheers

Hi Ian. Don’t hesitate to get in touch if you need to mate. Good luck with it . If you send me a PM, I will send you my phone number. Cheers

Hi ian, have a look at these mate. received_138534741470841.jpeg shows how flogged out my holes in the centreboard case was. you can see here the recess in the fibreglass where originally there was a rubber seal fitted in there to try and seal around the bolt. they were fitted from inside of the cav...

Hi Ian, you are doing a great job. Just remember that the thing that wears out the bushes around the pivot bolt and the holes in the sides of the centreboard case is sideways movement of the centreboard port to starboard, so it is vital that those thrust washers each side of the centreboard are larg...

Great job Ian. Well done. Should outlast the rest of the boat. Cheers

Thanks Ozzie, yes I will have to lower at least the back of the bunks if not both front and back as there is not much " swivel " in them but that should not be too much of a hassle.
cheers

Hi all. I thought I would update this post with how I improved on my bunks. I used thin 3 ply builders bracing ply. I bent up 6 pieces of steel 20mm x 5 mm to fit the hull at equal distances along the length of the bunk. Covered the hull with hot house plastic for protection. Adjusted the original b...

For mine, I turned up a nylon washer and a nylon cap that fits over both the head of the bolt as well as over the nut and fitted them with Silastic. Then I laid one layer of fibreglass over that on each side. If removal is required again at a later time, the layer of glass can be chiselled off again...